onsemi

78000

NPN small-signal bipolar transistor (BJT). It is used for general amplification and medium-speed switching applications, such as signal amplification, logic level conversion, driving small loads, etc.

ams-OSRAM AG

8000

940nm/950nm infrared light-emitting diode (IRED). It efficiently converts electrical energy into light output within the near-infrared spectrum, and is mainly used in applications such as infrared lighting, sensing, and data transmission.

SGMICRO

50000

42V/1.2A, 1.2MHz synchronous step-down converter. It efficiently and stably converts a wide input voltage range of 4.5V to 42V into a variable low voltage output (minimum 0.83V), which is particularly suitable for industrial power supplies and battery-powered systems.

STMicroelectronics

10000

600W bidirectional transient voltage suppression diode (TVS). When a momentary high-voltage surge occurs in the circuit, it responds at a picosecond speed, clamping the voltage within a safe range, thereby protecting subsequent sensitive circuits from damage.

TAIYO YUDEN

2000

Surface mount multilayer ceramic capacitors (MLCCs) are used for energy storage, filtering and decoupling in circuits. This series is mainly targeted at consumer electronic products such as mobile phones and portable devices.

TAIYO YUDEN

2000

Surface mount multilayer ceramic capacitors (MLCCs) are used for energy storage, filtering and decoupling in circuits. This series is mainly targeted at consumer electronic products such as mobile phones and portable devices.

Texas Instruments

5000

Single-channel 2-input XOR Gate (XOR Gate). It performs the logical function Y = A ⊕ B. When the two inputs are different, the output is a high level; when they are the same, the output is a low level.

Bourns Inc.

1000

Common mode choke/filter. It is used to suppress common-mode electromagnetic interference (EMI) in electronic circuits, by attenuating common-mode noise to ensure signal integrity.

Texas Instruments

10000

Single-path bus buffer with tri-state output. Its core function is to isolate signals in digital circuits, enhance driving capability, and achieve shared control of the bus through the "tri-state" output (high level, low level, and high-impedance state), which is commonly used for interface isolation, driving loads, or enabling control in microcontrollers (MCUs).

Intel

500

Tray.The 13th generation Core i7 mobile processor (CPU).

Microchip Technology

5000

Tube,Tape and Reel.16Mbit serial SPI NOR flash memory. It is used for storing program code, firmware or configuration data, and supports high-speed reading and writing through the SPI interface.

Onsemi

2000

Low-power dual-channel operational amplifier. It is used to amplify analog signals and can operate with either a single power supply or a dual power supply. It is commonly used in sensor signal conditioning, DC gain modules, power management and control circuits, etc.

Texas Instruments

20000

Dual-channel, low-power, industrial-grade voltage comparator. Its core function is to compare two input voltages and output corresponding digital levels based on the comparison result. It is commonly used in interfaces between analog signals and digital logic.

STMicroelectronics

5000

Low-power dual-channel operational amplifier. It is used to amplify analog signals and can operate with a single power supply (3V to 30V) or dual power supplies. It is commonly used in sensor signal conditioning, DC gain modules, etc.

Texas Instruments

2000

Four-channel differential voltage comparator. Its core function is to compare the magnitudes of two analog voltages (the in-phase terminal and the out-of-phase terminal) and output the corresponding digital level (high or low).

Texas Instruments

2000

A 100mA, adjustable positive voltage linear regulator. With just two external resistors, the input voltage can be reliably converted to any output voltage ranging from 1.25V to 32V.